21st Century - Tool - Standard Lathe 3 Way Trim Attachment - 6mm

**ATTENTION**

This is an ADDITIONAL trim attachment for Complete Standard Lathe kit part# XXI-908...

It does not function by itself.

The kit utilizes the same tail assembly with free-floating case holder and driver and as the neck turning set-up.  The difference is on the cutting tool end.  The neck turning tool it taken off and is replaced with a cutting head that incorporates a special caliber specific arbor with a custom-ground carbide cutter installed that trims the overall length and chamfers the inside of the case mouth.  In lieu of a neck turning cutter a carbide cutter is used to chamfer the outside diameter of the case mouth.
 
The kits for both the powered lathe or  the standard lathe comes with the following:
 
-Cutting tool head with carbide outside chamfer cutter
-Caliber specific trimmer arbor with carbide overall length/inside chamfer cutter
-Engineered dead-stop with micro and macro adjustment 
-Stainless steel long driver shaft (for standard non-power lathe)
-Three Allen wrenches for adjustment